Polycarbonate EV Charger Enclosure: Kiosk

Charging posts fail in public in the worst possible way: a cracked cover with the connector still live behind it. That is the reason polycarbonate EV charger enclosures have largely replaced acrylic on kerbside installations.

The units we quote most often are retrofit covers rather than full enclosures, because operators keep the metal chassis and replace only the front and side panels after a vandalism or vehicle contact incident.

Sheet specification for a polycarbonate EV charger enclosure

  • Front cover: 5 mm UV co extruded polycarbonate
  • Side returns: 5 mm, formed with a 15 mm inside radius
  • Base plinth: 6 mm flat panel for the mounting frame
  • Colour: opal white or tinted grey to hide the internals
polycarbonate EV charger enclosure housing a charging post outdoors

Opal white works better than clear on a public post. Clear panels show cable routing and dirt, and every scratch inside the housing becomes a service complaint. Opal diffuses the LED indicator and still passes enough light for maintenance checks.

Forming and the polycarbonate EV charger enclosure profile

Covers are line bent on a CNC bender rather than drape formed, because the profile is a simple U or box with square corners. Bending at 15 mm radius keeps the corner clear and avoids the stress whitening that shows up as a pale band after a year of sun.

Returns are bonded with a structural two part adhesive. Rivets alone let water in at the seam and produce a galvanic stain around the rivet heads on a wet kerb.

Fixings that survive thermal movement

Polycarbonate moves about 3 mm per metre over a 60 C surface swing. Holes for the fixing bolts should be 2 mm oversize with a bonded sealing washer, so the panel slides rather than splits at the hole.

River People forms charger covers to your chassis drawing, UV stabilised and edge trimmed, with protective film left on for installation. Send the footprint and annual batch to oversales@rpplexiglass.com.

Send your charger footprint, wall thickness and batch size to oversales@rpplexiglass.com for a quotation on formed charger enclosures.

Public posts take constant abrasion, and our polycarbonate scratch resistance guide explains which surface options hold up kerbside.

Frequently Asked Questions

Why polycarbonate for a charging post cover?

It holds impact strength at low temperature and resists a car bumper contact that would crack acrylic. UV co extruded sheet keeps colour and clarity for years outdoors.

What bend radius for a 5 mm formed cover?

At least 15 mm inside radius, which is three times the thickness. A tighter bend whitens the outside of the corner under light.

Does the enclosure need vents?

Yes, a louvered gap of 30 mm at the base and a 20 mm exhaust at the top. Sealed enclosures condense on the electronics within a season.