Polycarbonate Silo Inspection Window

Grain, feed and mineral silos all need the same thing: a way to look at the product level and the wall condition without opening a hatch. The polycarbonate silo inspection window does that job, and it survives being hit by a scoop shovel, which glass does not.

A feed mill replaced twelve glass windows after a single season. Every one had been broken during clean down, and two had dropped fragments into the product. The refit used 10 mm polycarbonate in bolted frames.

Load on a polycarbonate silo inspection window

The pane carries two loads: grain pressure when the silo is full and impact from tools during cleaning. Grain pressure at 3 m depth is roughly 30 kPa, which is modest, but the impact case dominates and sets the thickness.

  • Diameter up to 500 mm: 10 mm polycarbonate
  • Diameter 500 to 800 mm: 12 mm
  • Frame: 40 x 5 mm steel flat, bolted at 150 mm pitch
  • Gasket: closed cell EPDM, 25 percent compression
polycarbonate silo inspection window set into a grain silo wall

Fasteners go through a steel frame rather than directly through the pane. Bolting a 12 mm pane at eight points puts stress rings around every hole, and those rings crack first when a tool strikes the centre.

Fitting sequence and the polycarbonate silo inspection window seal

Frame first, gasket second, pane third, retaining ring last. Panes fitted before the frame is aligned cannot be brought square afterwards, and a skewed pane loads the gasket unevenly.

Dust abrasion and service interval

Fine mineral dust abrades polycarbonate slowly but visibly. In a cement or lime silo, plan on replacing windows every four to six years. Grain silos typically run eight to ten years before the surface haze justifies replacement.

River People supplies 10 mm and 12 mm polycarbonate inspection windows cut to your opening with frame and gasket kits. Send the silo drawing and stored product to oversales@rpplexiglass.com for a quotation.

Send the silo wall opening, product stored and inspection frequency to oversales@rpplexiglass.com for a quotation on framed inspection windows.

Silo windows are cut to an existing opening, and the polycarbonate cut to size service page covers cutting tolerance against a bolted frame.

Frequently Asked Questions

Why not glass for a silo inspection window?

Falling grain and cleaning tools break glass. Polycarbonate takes the impact and stays in the frame, which keeps the silo sealed.

What thickness for a 500 mm window?

10 mm for a 500 mm diameter, 12 mm above 600 mm. A thinner pane bows under grain pressure when the silo is full.

How is the window sealed against dust?

A closed cell EPDM gasket compressed to 25 percent in a bolted steel frame. Foam tape alone lets fine dust through within a season.