On a tracked machine the cab front is both windscreen and shield, so a polycarbonate excavator window is specified for repeated impact in the same place rather than for a single worst case event.
A demolition contractor in Manchester replaced three front panes on one 30 t machine in a season. Each had been struck by debris on the same lower left area, and each glass original had shattered into the cab.
Where a polycarbonate excavator window is loaded
Front screen
- Lower quarter: debris strikes, 10 mm
- Centre: view area, 8 mm with a scratch resistant face
- Top: weather, 6 mm
- Curved sections: formed, not cold bent beyond 300 mm radius
Sealing against dust and vibration
Tracked machines vibrate continuously, and a pane that is bolted hard against a steel frame frets at each bolt. A gasket plus a bolt with a rubber washer keeps the seal and stops the pane from chipping at the holes over months of work.
Wipers, dust and the view
A dry wiper on a dusty site grinds grit into the surface. Keeping the wipe wet and the blade clean is the practical defence, and a scratch resistant grade extends the interval before the pane has to be replaced for visibility rather than for damage.
Scratch behaviour is covered in polycarbonate scratch resistance.
Send your machine model, pane drawing and site conditions to oversales@rpplexiglass.com for a quotation.
Frequently Asked Questions
Which thickness for an excavator front pane?
8 mm for a standard machine, 10 mm for demolition or forestry attachments. The front pane takes the most material and is usually the first to be replaced.
Can polycarbonate be curved for a cab front?
Yes, in a controlled bend or by thermoforming to a cab template. Cold bending works to a gentle radius; a tight compound curve is formed over a mould.
Will a standard wiper scratch the pane?
A wiper with a dry rubber blade will mark polycarbonate over time. A wet wipe cycle and a blade in good condition keep the surface clear, and a scratch resistant grade helps on dusty sites.
