A polycarbonate haul truck window earns its place by surviving what a pit throws at it: rock spill from a loaded body, dust cut by the wheel, and a driver who cannot see the berm if the pane hazes.
Fleets do not buy glazing on optical clarity. They buy on hours between replacements, and that number is set by thickness, coating and how the panel sits in the frame.
Thickness and the polycarbonate haul truck window
- Front and side panes: 12 mm clear PC, hard coated
- Rock exposure zones: 16 mm, laminated PC
- Haze limit after 500 cycles: 2 percent
- Service temperature: minus 20 C to 70 C at the cab face
Twelve millimetres stops the rock strikes that break laminated glass of the same weight, and it does it without the spall risk that glass carries into a cab. Sixteen is the specification for the zones directly behind a loading pass, where a fist sized rock arrives at speed.
Dust, abrasion and the polycarbonate haul truck window face
Dust is the real abrasive in a pit. Haul road grit at 10 microns works a polycarbonate face like a lapping compound, and an uncoated pane loses clarity within a service interval. A hard coat of 5 microns plus a weekly wash with water, no dry wipe, holds the face for two to three times as long.
Seals and cab pressurisation
Most mining cabs run positive pressure to keep silica out. A window that leaks at the clamp defeats the filtration system, and the driver reports it as dust on the dash rather than as a glazing fault. EPDM gaskets on a 3 mm land, with a torque spec on the bolts, close that path.
River People cuts haul truck panes to the cab drawing with hard coat and gasket sets, and supplies spare panels per fleet. Drawings go to oversales@rpplexiglass.com.
Send the cab model, window drawing and fleet size to oversales@rpplexiglass.com for a quotation with spare panel sets per truck.
Coating and haze numbers are covered in our polycarbonate scratch resistance guide.
Frequently Asked Questions
How long does a PC cab window last in a pit?
Two to three times a glass pane on the same route, provided the face is hard coated. Uncoated panels haze from dust within one service interval.
Why do panels crack at the mounting bolts?
Point loading. Bolts torqued against a bare panel edge start a crack that runs across the pane in weeks. A gasketed clamp spreads the load.
Can the window be changed in the field?
Yes, with a pre drilled panel and a torque spec. Most fleets carry one spare set per five trucks and swap at the fuel bay.
