A polycarbonate piggery window fails in a way no catalogue photograph shows: fine cracks along the clamped edge, appearing after two or three wash down cycles, letting in water that nobody sees until the wall is opened.
The cause is a combination, alkaline detergent plus ammonia in the air, and it is entirely avoidable with the right construction detail.
Twinwall build and the polycarbonate piggery window
- Glazing: 10 mm twinwall for refurbishment, 16 mm for new build
- U value: 2.3 and 1.8 W per square metre kelvin
- Light transmission: 75 to 80 percent, clear or opal
- Edge: sealed both ends, taped and capped
Sixteen millimetre twinwall on a new building gives a U value of 1.8 and keeps the inner face above the dew point through a winter ventilation cycle. Ten millimetre is the sensible retrofit where the frame depth is fixed, at the cost of condensation on the coldest mornings.
Ammonia, disinfectant and the polycarbonate piggery window
Polycarbonate is attacked by strong alkalis, and a pig building is full of them: ammonia from slurry, caustic wash on turnaround, and hypochlorite fogging. The material survives all three when the panel is not under mechanical stress at the same edge. That is why a clamped centre with a gasketed, low torque fixing outlasts a bolted panel.
Fitting that survives a wash down
A 5 degree fall to the outside, a sealed flute end and a cap on the top edge stop water entering the channels. Panels fitted dead level collect condensate in the flute, algae grows, and the window goes green from the inside where cleaning cannot reach.
River People supplies twinwall cut and capped to your opening, with opal or clear grades and fixing kits. Building drawings go to oversales@rpplexiglass.com.
Send your building drawing, ventilation rate and wash chemicals to oversales@rpplexiglass.com for a quotation on twinwall glazing cut to the opening.
The sister application in broiler housing is described in our poultry house window guide.
Frequently Asked Questions
Does ammonia attack polycarbonate?
Sustained ammonia plus alkaline wash builds stress cracking at clamped edges. A 10 mm twinwall with a sealed edge and unclamped centre resists it far better than a thin single skin.
What U value does twinwall give?
About 2.3 W per square metre kelvin at 10 mm and 1.8 at 16 mm. Both are well below single glazing and above the triplewall range.
Why do panels go green?
Algae in the flutes from condensation, not a material change. Sealed edges and a 5 degree slope stop water sitting in the channel.
