Polycarbonate Isolator Glazing: Pharma

Polycarbonate isolator glazing is chosen for one reason in pharmaceutical suites: it does not break. A glass pane inside a validated barrier is a deviation waiting for a trolley.

The second reason, and the one that decides the grade, is chemistry. The glazing sees hydrogen peroxide vapour on every decontamination cycle, and it has to come out of that cycle clear.

Material and the polycarbonate isolator glazing

  • Wall glazing: 10 mm clear PC, 12 mm for full height
  • Glove ports: 12 mm, port flange bonded before assembly
  • Surface: both faces polished, no release agent
  • Pressure: 100 to 200 Pa positive, leak tested as built
polycarbonate isolator glazing on a pharmaceutical filling line

Acrylic is clearer and cheaper and it crazes under repeated VHP within a year, which shows as a white haze band at the fill line height, exactly where the operator needs to see the needles. Polycarbonate at 10 mm hazes far more slowly and keeps its impact margin, which is the trade a validated suite should accept.

Joints, gloves and the polycarbonate isolator glazing

Every joint in an isolator is a leak path. A pane bonded into a stainless frame with a structural silicone on a 6 mm land, then gasketed at the outer face, gives two barriers instead of one. Drilling a glove port through a finished pane is the mistake that fails a smoke test: the flange must be bonded before the wall is assembled.

Wipe down and the surface finish

A polished face wipes to a residue free finish in one pass; a sawn or sanded face holds residue in the scratch pattern and shows up in a cleaning validation swab. Both faces are polished for that reason, not for appearance.

River People supplies isolator panels cut, polished and bonded to drawing, with compatibility notes per cleaning agent. Drawings go to oversales@rpplexiglass.com.

Send the isolator drawing, decontamination cycle and pressure regime to oversales@rpplexiglass.com for a quotation with material compatibility data.

Panel sizing and polishing for barrier glazing is explained in our polycarbonate cut to size guide.

Frequently Asked Questions

Is polycarbonate compatible with VHP cycles?

Repeated hydrogen peroxide vapour cycles leave a slow haze on polycarbonate but do not embrittle it at 10 mm. Acrylic crazes far sooner and is the wrong choice for a VHP line.

Which thickness for a filling isolator?

10 mm for half suits up to 1.2 m, 12 mm for full height walls and any pane carrying a glove port.

How is the glazing leak tested?

As part of the isolator, at the specified pressure hold, typically 100 to 200 Pa with a defined decay. The pane and its gasket are tested together, never separately.