Polycarbonate Pass Box Window: Cleanroom

A polycarbonate pass box window is a pressure boundary, a viewing port and a cleaning surface at once, and it is the component most often specified last in a cleanroom fit out.

The consequence is predictable: the box arrives with glass, the glass breaks during commissioning, and a polycarbonate replacement is cut in a hurry without the gasket detail.

Panel and the polycarbonate pass box window

  • Door glazing: 6 mm clear PC, 8 mm above 600 mm
  • Fixed viewing panel: 6 mm, flush both faces
  • Haze limit: 2 percent after cleaning cycles
  • Edge: polished, never sawn, on the viewing face
polycarbonate pass box window on a cleanroom transfer hatch

Six millimetres carries the interlock door load without visible deflection at 600 mm, and it survives the accidental trolley strike that takes glass out during commissioning. Above 600 mm the pane needs 8 mm, because deflection at the hinge side disturbs the door seal and the leak test fails.

Seals, cleaning and the polycarbonate pass box window

Silicone gaskets on a continuous 3 mm land, with the pane clamped rather than bolted through the edge, keep the pressure boundary and stop particle ingress at the joint. Bolted panes with drilled holes leak at every hole, and the particle counter finds it in the first classification run.

Cleaning agents that shorten panel life

Daily IPA wipe down dulls polycarbonate over a year, and the dulling shows as a haze reading at the inspection window, not as a visible scratch. Neutral detergent with a microfiber wipe, and IPA only for spot spills, keeps the face clear through a validation cycle.

River People supplies pass box glazing cut and polished to the drawing, with gasket sets and torque guidance. Drawings go to oversales@rpplexiglass.com.

Send the pass box drawing, cleanroom class and cleaning agents to oversales@rpplexiglass.com for a quotation on glazing with gaskets and fixings.

Wall and gasket detail for the rest of the room sits in our cleanroom partition guide.

Frequently Asked Questions

Which thickness for a 600 mm pass box door?

6 mm for doors up to 600 mm, 8 mm above that or where the interlock adds weight to the pane.

Can the window be cleaned with IPA?

Isopropyl alcohol is tolerated on polycarbonate for occasional wipe down but repeated daily use dulls the face. A neutral detergent with a soft wipe is the routine that keeps haze below 2 percent.

Does glazing affect the cleanroom class?

Only through the seal. A gasketed pane on a continuous land holds class; a bolted pane with gaps leaks particles at the joint and shows up in the particle count.