Most coupling incidents are not caused by a missing guard. They happen when a fitter takes the guard off to look at the coupling and does not put it back before restart. A polycarbonate pump coupling guard removes that step, because the coupling is visible through it.
A water utility standardised clear guards across 60 pumping stations and cut guard removals for inspection by roughly 80 percent, according to its own maintenance log.
Clearance and the polycarbonate pump coupling guard envelope
- Sheet: 6 mm for couplings under 150 mm diameter
- Sheet: 8 mm for larger or high speed couplings
- Radial clearance: 6 mm to the rotating envelope
- Aperture for oil check: 40 x 25 mm, screened
The guard envelope follows the largest rotating diameter, which is usually the coupling bolts rather than the hub. Measure with the bolts fitted; a guard built to the hub size fouls the bolts at speed and rubs a ring into the panel.
Fixing and the polycarbonate pump coupling guard on a base frame
Guards bolt to the base frame, not to the pump casing. Casing mounted guards move with thermal growth and open a gap at the motor end, which is exactly where the shaft is least protected.
A check that proves thickness
At running speed a thin guard visibly flexes. A 6 mm guard over a 250 mm envelope at 3000 rpm shows a flutter that a 8 mm guard does not. If the panel moves in service, it is too thin for that speed regardless of the clearance calculation.
River People cuts and forms coupling guards to your pump envelope with edge trim and fixing holes drilled to the base frame drawing. Send the coupling size and speed to oversales@rpplexiglass.com for a quotation.
Send the coupling diameter, shaft speed and frame layout to oversales@rpplexiglass.com for a quotation on cut and formed coupling guards.
Guards around rotating equipment follow the same rules, and the polycarbonate machine safety guards guide covers clearance and fixing practice across machine types.
Frequently Asked Questions
What clearance is allowed between guard and coupling?
Machine guarding practice uses 6 mm maximum gap at the rotating part, or a distance that prevents finger entry. Larger gaps invite tools and fingers.
Does polycarbonate stop a coupling failure?
It contains fragments and prevents contact. A polycarbonate guard is not a structural shield against a shaft break, so the mounting frame carries that duty.
Why clear rather than solid steel?
Fitters can inspect the coupling for wear and oil leak without removing the guard, which is when most contact incidents happen.
