Polycarbonate Ski Lift Window: Alpine Glazing

A resort in the Italian Alps replaced 96 polycarbonate ski lift window panels after a season in which two panels cracked at a bolt hole and one ski pole went through a side pane. The panels had been cut to the frame size, bolted tight, and run at 6 mm without coating.

Three changes fixed all three failures without changing thickness.

The polycarbonate ski lift window fixing pattern

  • Hole: 2 mm oversize on the bolt diameter, every fixing
  • Edge clearance: 3 mm per metre of panel length
  • Washer: 3 mm EPDM on both faces, no metal to sheet contact
  • Bolt torque: snug plus a quarter turn, never a torque figure
polycarbonate ski lift window on a chairlift cabin in snow

Thermal movement is the whole story at altitude. A 700 mm panel moving through a 45 C swing expands and contracts by about 2 mm. A tight bolt pattern forces that movement into the hole, and the hole becomes the crack origin every time.

Impact and the polycarbonate ski lift window in service

At 6 mm, polycarbonate absorbs a ski pole strike that would shatter tempered glass. The panel may dent and recover, and the passenger stays inside the cabin. Where a resort wants the strike recorded, a sacrificial 3 mm outer pane over the structural 6 mm gives a replaceable wear layer at a known cost.

Condensation and the polycarbonate ski lift window at first light

A single pane fogs on the inner face when a loaded cabin warms quickly. Twinwall isolates the inner face and drops the fog risk, at the cost of some clarity at an angle. Anti fog coating on a single pane works for a season, then needs reapplying, which a resort maintenance team rarely does on schedule.

River People supplies cabin sets cut to frame drawings with oversize fixings and gaskets. Send panel count per cabin and altitude to oversales@rpplexiglass.com.

Send the cabin frame drawing, panel count per cabin and resort altitude to oversales@rpplexiglass.com for a quotation on a full cabin set.

Where a cabin contour cannot be drape formed, the limits of the alternative are set out in polycarbonate cold bending practice.

Frequently Asked Questions

Does polycarbonate stay clear at minus 30 C?

It keeps its impact performance where glass and acrylic become brittle, and it stays transparent. The risk is not the panel material but a fixing that stops the sheet contracting.

Single pane or twinwall?

Single pane 6 mm for a gondola where weight matters, twinwall 6 mm where condensation on the inner face is the complaint.

Can scratches be polished out on site?

Only on uncoated sheet. A hard coated window is replaced rather than polished, and that is the trade for a five year service life.