Acrylic Gelato Display: Freezer Case

A gelato chain in a coastal city replaced 60 acrylic gelato display tubs after one summer, all with the same complaint: white crazing along the top rim, visible through the case glass.

The material was not at fault. The routine was: tubs came out of a minus 18 C case and went straight into a wash bay at 65 C, twice a day, for four months.

Acrylic gelato display: one shift, four steps

Step one, selection. A 5 mm cast wall for tubs up to 400 mm long, 6 mm above that. Anything under 4 mm chips where the scoop strikes the rim during scraping.

Step two, the case. Tub height must clear the case lid by 15 mm so the tub is lifted out rather than dragged across the evaporator rail, which is where most rim damage starts.

acrylic gelato display tubs and lids in a freezer case

Step three, the wash. Temper for 10 minutes on the bench, wash at 60 C with neutral detergent, rinse, then air dry on edge. A tub that goes straight from the case to hot water takes a thermal shock of 80 K, and cast PMMA does not enjoy that.

Step four, stacking. Tubs stack two high at most, with a spacer between them. Four high loads the bottom rim and produces the deformation that reads as a warped tub under case lighting.

Lid fit and the acrylic gelato display

A lid that sits loose lets cold air escape and forms frost on the gelato surface, which customers read as old stock. A 1 mm clearance on the tub lip with a 6 mm skirt holds the cold without jamming when the tub shrinks at freezer temperature.

What the case lighting reveals

Freezer LED strips show every scratch at a grazing angle. Polished rims and flame treated surfaces scatter less light than sawn edges, and the difference is obvious in a photograph taken through the case glass.

River People builds tubs and lids to your case layout, with logos engraved and spare rims supplied per store. Dimensions go to oversales@rpplexiglass.com.

Send your tub dimensions, case layout and daily wash routine to oversales@rpplexiglass.com for a quotation on tubs, lids and display risers.

Shops that also need formed rather than bonded containment can compare with our PETG display box guide.

Frequently Asked Questions

Does acrylic survive a gelato freezer?

Clarity and stiffness hold at minus 18 C, but impact strength falls. A 5 mm wall tolerates scoop contact; a 3 mm wall chips at the rim within one season.

Why do lids craze at the rim?

Thermal shock between the freezer and a warm wash bay. Allowing a 10 minute temper before washing removes most of it.

Can tubs be supplied with brand engraving?

Yes, engraved on the base or the lid edge. Surface printing on the inside face is removed by washing within weeks.