A regional museum opened a 2,400 square metre gallery with eleven acrylic museum vitrines, and within the first month the conservation team logged humidity swings of 12 percent inside four of them. The panels were correct. The gasket had been chosen by the fit out contractor from what was in the van.
That is the pattern in this category: the acrylic is usually right and the sealing is usually wrong.
Thickness, span and the acrylic museum vitrine
- Panel: 8 mm to 12 mm low iron cast, optical quality
- Span without a mid rail: 900 mm at 8 mm, 1,500 mm at 12 mm
- Weight: 11.9 kg per square metre at 10 mm
- Edge: polished, then welded, then re-polished
Deflection is the number that decides thickness, not appearance. A 1.2 m wide panel at 8 mm bows visibly under gallery spot lighting because the reflection moves with the bow, and visitors read that movement as a wobbling case.
Gaskets, seams and the acrylic museum vitrine climate
A vitrine is a climate vessel. Silicone gaskets hold humidity but release acetic acid during cure, which is exactly what a metals collection cannot take. EPDM or closed cell polyethylene are the safe choices, and the case needs 72 hours of venting before an object goes in.
Reflections and lighting
Acrylic cannot carry an anti reflective coating the way glass can, so reflection control comes from geometry: a slight forward tilt on the front panel and a light source outside the visitor angle removes most of the glare without a coating.
River People builds vitrines to your case drawing, with welded or clamped joints and gasket options documented. Drawings go to oversales@rpplexiglass.com.
Send the case dimensions, artefact load and climate requirement to oversales@rpplexiglass.com for a quotation with a joint sample.
Case glazing tolerances are covered in more depth in our museum display case glazing guide.
Frequently Asked Questions
Why low iron acrylic for a vitrine?
Standard cast carries a green edge tint that shows on thick panels and shifts the artefact colour. Low iron cast holds a neutral edge at 10 mm and above.
Welded or clamped joints?
Welded for sealed cases under 1.5 m, clamped with gaskets for cases that will be opened for rotation. A welded case cannot be reopened without cutting.
How is the case cleaned?
Soft cloth with a neutral detergent, never alcohol. Alcohol crazes cast acrylic over repeated use and the craze reads as a scratch under gallery lighting.
