Polycarbonate Gaming PC Case: Side Panel

A polycarbonate gaming pc case side panel exists because builders move their machines: to a friend flat, to a lan event, into a car boot. Tempered glass wins the photograph and loses the trip.

The engineering question is whether the panel survives handling and still looks clean after a year of it.

Thickness and the polycarbonate gaming pc case panel

  • Mid tower side panel: 3 mm clear PC, hard coated
  • Full tower and show builds: 4 mm
  • Light transmission: 88 percent at 3 mm
  • Standoffs: 6 mm, isolated from the panel by nylon washers
polycarbonate gaming pc case side panel with visible components

Three millimetres is stiff enough across a 450 mm span that it does not drum when fans spin up, and thin enough to bend instead of cracking at a corner screw. Four millimetres suits a full tower where the panel spans 550 mm and the build is meant to be shown.

Hard coat, scratches and the polycarbonate gaming pc case

The first scratch usually comes from a screwdriver slipping during assembly, across the inside face. A 3 to 5 micron hard coat takes that scrape without a permanent mark, and it keeps the face clean through the dust that a mesh front pulls in.

Cut outs, airflow and finish

Vent cut outs belong on the rear panel, not the side, or the panel becomes an intake and dust films the inside face within months. A polished edge on the visible border, and a 1 mm chamfer on the fixing holes, removes the stress risers where cracks start.

River People supplies case panels cut, hard coated and edged to the chassis drawing, with fixings matched to the standoff pattern. Drawings go to oversales@rpplexiglass.com.

Send the chassis drawing, panel size and finish requirement to oversales@rpplexiglass.com for a quotation on panels with hard coat and edge treatment.

Hard coat performance on machine guards, the closest duty cycle to a case panel, is tested in our hard coated sheet guide.

Frequently Asked Questions

Why not tempered glass?

Glass gives a flatter reflection but shatters on a lan party floor. Polycarbonate bends, and a bent panel still fits the case.

Does internal heat soften a PC panel?

No at 3 to 4 mm. Chassis air runs 40 C to 65 C, well below any deflection point, and the panel is not load bearing.

What about dust and cleaning?

Dust wipes off a hard coated face with a dry microfiber cloth. Uncoated sheet attracts dust and scratches in the same wipe.