Polycarbonate Skylight Dome: Roof Glazing

Six questions decide whether a polycarbonate skylight dome is still clear at year ten or whether it has yellowed into a lantern. None of them is about price, and all six can be settled before the order.

The list below is the one worth sending to a supplier.

Polycarbonate skylight dome procurement checklist

  • UV protection: co extruded cap on the weathered face, verified on a cut edge
  • Thickness: 4 mm up to 1,000 mm clear span, 6 mm beyond
  • Curb: thermal break, no direct metal to sheet contact
  • Edge: 5 mm clearance inside the frame for thermal movement
  • Seal: EPDM gasket, dry glazed, no silicone against the edge
  • Pitch: minimum 5 degrees, 15 degrees where snow sits
polycarbonate skylight dome above a flat roof

The co extruded cap is the item most often assumed rather than checked. A cheap dome is often mass tinted, which protects the polymer for a few years and lets the sheet yellow from the surface inward. A cut edge under a black light shows the cap as a bright line, and that check takes ten seconds on site.

Curb detail and the polycarbonate skylight dome thermal break

Condensation on a dome is a curb problem. Metal conducts cold straight to the glazing line, the inner face drops below the dew point, and water runs down the inside of the dome. A 10 mm thermal break strip between the sheet and the aluminium, plus a drained channel under the glazing line, keeps the water outside the building.

Snow, span and the polycarbonate skylight dome pitch

Snow load is what breaks domes, and pitch is what sheds it. At 5 degrees a 600 mm snow layer sits and loads the sheet evenly; at 15 degrees it slides before it builds. For a roof in a snow region, the cheaper answer is often a steeper pitch rather than a thicker sheet.

River People supplies domes and flat panels to your opening with UV co extruded sheet, thermal break details and dry glazed edges. Send the opening size and climate to oversales@rpplexiglass.com.

Send the opening size, roof pitch and location climate to oversales@rpplexiglass.com for a quotation with a curb detail drawing.

Flat rooflights and their curb details are set out in polycarbonate skylight specification.

Frequently Asked Questions

How is UV protection verified on a dome?

By the co extruded cap on the cut edge. A protected sheet shows a thin layer and a UV fluorescence under a black light; a mass tinted or unprotected sheet does not.

What span does 4 mm carry?

About 1,000 mm clear span for a 4 mm dome before snow load governs. Above that, 6 mm and a steeper pitch.

Why does a dome drip?

Because the inner surface falls below the dew point. A thermal break between the dome and the metal curb moves the cold bridge away from the glazing line.